Missing information in Navisworks

2 Beiträge / 0 neu
Letzter Beitrag
AZ Scanning
Offline
Last seen: vor 9 Jahre 7 Monate
Beigetreten: 08.08.2014 - 00:15
Missing information in Navisworks

Hello Everyone, I have a problem I am encountering when I export my point cloud into either Autodesk Recap or Navisworks. A large chunk of the cloud goes missing, When I am in Cyclone which is what was used to register i see all of the data. Its only during export that the problem becomes visible.

Any Ideas as to why?

Thank you all.

Forum Schlüsselworte: 
Eric_Bergholz
Offline
Last seen: vor 2 Monate 1 Woche
Beigetreten: 18.11.2008 - 22:17
export faro data to autodesk

Hi,

I think one problem can be, that the autodesk data base, which allows you handle big data, are not same powerfull
like leica cyclone. It can be, that less points will display on your screen. I have seen, that in same Autodesk application you tell the software, how big is your machine and how much points should be display then.

regards.. ..Eric

Eric Bergholz
Laserscanning Europe GmbH